Biomechanical evaluation of an expandable meshed bag augmented with pedicle or facet screws for percutaneous lumbar interbody fusion

Objective: To evaluate the biomechanics of lumbar motion segments instrumented with stand-alone OptiMesh system augmented with posterior fixation using facet or pedicle screws and the efficacy of discectomy and disc distraction.

Background context: OptiMesh bone graft containment system has been used for vertebral compression fractures and percutaneous lumbar interbody fusion. The filled mesh bag serves as the interbody device providing structural support to the motion segment being fused. No biomechanical data of this new device are available in the literature.

Methods: Twenty-four fresh human cadaveric lumbar motion segments were divided into two groups. In the control group, multidirectional flexibility testing was conducted after an intact condition and standard transforaminal lumbar interbody fusion (TLIF) procedure. In the OptiMesh group, testing was performed following intact, stand-alone OptiMesh procedure, OptiMesh with facet screws (placed using the transfacet approach), and OptiMesh with pedicle screws and rods. Range of motion (ROM) was calculated for each surgical treatment. The lordosis and disc height change of intact and instrumented specimens were measured in the lateral radiographs to evaluate the disc space distraction. In the OptiMesh group, cyclic loading in flexion extension (FE) was applied to measure cage subsidence or collapse (10,000 cycles at 6 Nm). After biomechanical testing, all the specimens were dissected to inspect the discectomy and end plate preparation. The area of discectomy was measured.

Results: The mean ROM of the intact specimens was 2.7°, 7.4°, and 7.2° in axial torsion (AT), lateral bending (LB), and FE, respectively. There was no difference between the control group and OptiMesh group. The mean ROM of the stand-alone OptiMesh system decreased to 2.4°, 5.1°, and 4.3° in AT, LB, and FE. The ROM decreased to 0.9° in AT, 2.2° in LB, and 0.9° in FE with OptiMesh system and facet screws. On average, OptiMesh system with pedicle screws and rods reduced the ROM to 1.3° in AT, 1.6° in LB, and 1.1° in FE. Compared with the intact condition and stand-alone OptiMesh system, both posterior fixation options had significant statistical difference (p<.001). In AT, ROM of facet screws was lower than that of pedicle screws (p < .05). There was no statistical difference between the facet and pedicle screws in LB and FE (p > .05). The mean volume of bone graft packed into each bag was 8.3 ± 1.5 cc. The average increase of lordosis was 0.6° ± 1.0° after meshed bag was deployed. The average distraction achieved by the OptiMesh system was 1.0 ± 0.6 mm. The average prepared area of discectomy was 42% of the total disc. The disc height change after cyclic loading was 0.2 mm. No subsidence or collapse was noticed.

Conclusions: The OptiMesh system offers large volume of bone graft in the disc space with small access portals. The OptiMesh system had similar construct stability to that of standard TLIF procedure when posterior fixation was applied. However, the amount of distraction was limited without additional distraction tools. With the anterior support provided by the expandable meshed bag, facet screws had comparable construct stability to that of pedicle screws. Slightly higher stability was observed in facet screws in AT.